Engineering & Automation

Engineering support that makes sure the equipment we supply suits your system, and practical help to install, commission and improve it.

Services

Available on their own or alongside equipment supply. We agree the scope, deliverables and responsibilities with you in writing before work starts.

Technical specifications and datasheets that suppliers can quote against without guesswork.

Comparison of offers on ratings, materials, standards, lifecycle and support, not price alone.

Controller and operator-panel hardware selection, configuration and programming support.

Migration from obsolete controllers, drives and networks to current, supported platforms.

Panel layouts, component selection and coordination with panel builders.

Selection and integration of transmitters, analysers and control valves into existing systems.

Supervision of installation work on site to the manufacturer’s requirements and your specification.

Coordination of pre-commissioning checks, start-up and handover documentation.

Fault finding on equipment and control systems, and identification of correct replacement parts.

Practical changes that improve reliability, energy use and maintainability.

Drives, soft starters and protection sized from the motor and the load, with the reactors, filters and braking resistors the installation needs.

PLC and HMI systems for batching, pumping, dosing and utilities, with I/O and networking matched to the plant.

Field instruments, signal conditioning and fieldbus or Ethernet networks that deliver reliable data to the control system.

Control panels, interlocks and distribution that are documented, safe to maintain and ready for future expansion.

Engineering knowledge is what lets us source equipment that is compatible, not just similar.

We check voltage, frequency, ratings and protection classes against your site conditions.
We confirm firmware versions, communication protocols and interfaces before replacing automation hardware.
We review materials, standards and certification requirements with the manufacturer before an order is placed.
Where an exact part is no longer available, we propose a technically justified alternative and explain the differences.

Send it as it is: a spreadsheet, a drawing or a photo of the nameplate. An engineer will review it and come back with questions or a quotation.